Bloosman
New Member
Hi folks...
Can I be so bold as to re-open this thread...???
I have recently obtained a BD.2 in reasonable condition...
A couple of the suspension-spring mounts are broken, and the motor appears rather loose.
The first issue I can fix, but the motor has me baffled.
The tiny elastic bands used to suspend the motor unit beneath the "Spider" aren't perished and appear fairly new, but when I connect the belt to the platter (which is heavier than I imagined it would be), the entire motor and pulley assembly is pulled quite a bit off the vertical...
Should this happen...?
I assume that if I try to connect the motor in a more direct fashion to the turntable body I will experience quite a bit of rumble...???
Can I be so bold as to re-open this thread...???
I have recently obtained a BD.2 in reasonable condition...
A couple of the suspension-spring mounts are broken, and the motor appears rather loose.
The first issue I can fix, but the motor has me baffled.
The tiny elastic bands used to suspend the motor unit beneath the "Spider" aren't perished and appear fairly new, but when I connect the belt to the platter (which is heavier than I imagined it would be), the entire motor and pulley assembly is pulled quite a bit off the vertical...
Should this happen...?
I assume that if I try to connect the motor in a more direct fashion to the turntable body I will experience quite a bit of rumble...???