TheManWhoBuiltTheMoon
pfm Member
Does anyone know when any of these boards will be made available to purchase. I’m very keen to hear them in an amp.
Does anyone know when any of these boards will be made available to purchase. I’m very keen to hear them in an amp.
Sadly Les doesn't seem to be in that "bare board" market any more
I'd e surprised if the only thing available is fully built boards at higher prices
I’d be happy with a fully built, drop in board.Sadly Les doesn't seem to be in that "bare board" market any more
I'd e surprised if the only thing available is fully built boards at higher prices
Close to completing my first pair of SE200 boards. What bias current is required?
I’d be happy with a fully built, drop in board.
Close to completing my first pair of SE200 boards. What bias current is required?
No, just got a BoM with a bag of components.Did Les not specify when he supplied them?
Thanks Graham….I suspected it would be in that ballpark, but best to check.60mA I was told. I have run at 100mA without issue with a large heat sink, they run warm at that bias.
Just to add...there is no sonic benefit to running at 100mA as I can tell.
Looking forward to your impressions on how they sound!Thanks Graham….I suspected it would be in that ballpark, but best to check.
60mA I was told.
Do you mean the true “bias current”, measured across the (presumably) two 0R22 output resistors, or the “idle current”, drawn by the positive rail? These terms seem to get mixed up here.
but what do they sound like?
I've been wondering if there were any locations in my NCC300 boards that would benefit from Z-Foils