Clem Fandango
Helidoc
It says in the guidance document for setting up the speakers that is provided with them and is available on line through the ATC website.Where did they say nt to use <2.5mm2?
It says this in the manual which is available on line:Where did they say nt to use <2.5mm2?
"3 : Connection (Passive Models)
ATC Entry Series monitors are equipped with a “bi-” or “tri-wire” connection panel that enables separate amplification of the bass/mid driver and tweeter. Remove the linking bars between the pairs of terminals if you wish to take advantage of this facility.
The pairs of binding posts are laid out to match the drive unit positions with the bass driver pair towards the lower edge of the input panel. Ensure the multiple amplifiers used for
bi or tri-amping have equal gain and use the most powerful amplifier for the LF driver. The terminals can accommodate either stripped cable ends or 4mm plugs.
Always use good quality speaker cable with a 2.5mm2 minimum cross sectional area per conductor (79 strand). Cable of a smaller cross sectional area or fewer strands is unsuitable.
For cable runs longer than 5m use a significantly heavier gauge cable. Consult our dealer or consultant for specific cable recommendations. Ensure that the positive and negative terminals on each connection panel are connected back to the corresponding positive and negative terminals on the amplifier."
Hope that this is helpful.