JoeJoe
pfm Member
I prefer the sound of the stock rubber mat to any other after-market mat I’ve bought but there’s an issue; it’s too low for my Goldring G1042 cartridge. It’s only out by a couple of mm or so but impossible to get the arm perfectly parallel, even with the height adjustment ring just below 0, right at its end-stop.
I’m also using the stock headshell that came with the 1200g.
I’m asking if anyone can recommend a good headshell that’s more accommodating than the Technics that would give me that few coveted mm I need for the G1042?
Or, I think I read somewhere, that Technics themselves produced a thicker version of their rubber mat, does anyone know if it’s still available or what the Technics line code for it was?
I have seen a few threads here and there about this arm-height issue with the Technics on certain cartridges but never took any notice until now…..
I’m also using the stock headshell that came with the 1200g.
I’m asking if anyone can recommend a good headshell that’s more accommodating than the Technics that would give me that few coveted mm I need for the G1042?
Or, I think I read somewhere, that Technics themselves produced a thicker version of their rubber mat, does anyone know if it’s still available or what the Technics line code for it was?
I have seen a few threads here and there about this arm-height issue with the Technics on certain cartridges but never took any notice until now…..