cj66
pfm Member
Said arm has been in a drawer for years now.
It has a bias problem, wanting to veer strongly outwards from the decks spindle, to the point of being unusable .
I have assumed this was due to a rather naff rewire that was done to it, I'm reasonably sure the DIY loom used is too stiff and badly executed, plus a completely missing pillar bung/plug/thingamywotnot.
Maybe my Googling skills are failing me but I can't seem to find a "standard" rewire kit. Everything seems to be the Carlos Fandango Super-pooper upgrade for a hundred notes plus. Am I wrong to not want to spend the original value of the entire arm on a few lengths of wire?
Anyway, recommendations invited on a kit/way to get the arm operational again for far less sqiddlies are invited.
It has a bias problem, wanting to veer strongly outwards from the decks spindle, to the point of being unusable .
I have assumed this was due to a rather naff rewire that was done to it, I'm reasonably sure the DIY loom used is too stiff and badly executed, plus a completely missing pillar bung/plug/thingamywotnot.
Maybe my Googling skills are failing me but I can't seem to find a "standard" rewire kit. Everything seems to be the Carlos Fandango Super-pooper upgrade for a hundred notes plus. Am I wrong to not want to spend the original value of the entire arm on a few lengths of wire?
Anyway, recommendations invited on a kit/way to get the arm operational again for far less sqiddlies are invited.