Finally got hold of my Linn dealer, and I now have all the bits on order motor, pulley, and 45rpm adapter. He hadn't heard of moving the motor in and out based on pulley size, but he did explain how to adjust the speed by tilting the motor. He also suggested using an old belt for 45rpm since it will get stretched. So everything makes sense now.
So now while I'm waiting for everything, I'll see if I can repair and sell off my Lingo to pay for all of this.
I'll have a look in my LP12 setup manual later (if I remember). The motor mounting holes are slots - but they are very short slots and you can only move the motor a millimetre or so.
Anybody tried geddon on 33 1/3 and modified Valhalla for 45 with a switch ? Sort of Hercugeddon
How about a Lingo after an isolation transformer? Can a Lingo push the higher viscosity oil in the bearing?
it's design ethos is quite different to the Armageddon and not really compatible with high drag bearings.