Mike Hanson
Trying to understand...
Now that I've finished replacing the NCC200 boards with NC220s in my Voyager mono amps, I'm using the NCC200s in a new amp. Here's the layout:
- The case is a Modushop Pesante.
- Power comes in the top right corner, with a fuse near the IEC socket. The raw power will run down the right side.
- That's an Avondale SSM2 in the bottom right. The switch will be below it. (I believe I have to connect the sensor pins on the SSM.)
- It's a single 500VA transformer, but one CAP6 per channel. Hence the terminal block.
- The CAP6 modules will be rotated 180 degrees, so the AC input is on the outside, with DC up the center to the amp boards.
- The NCC200s are positioned that way to enable short runs from the RCA inputs, without the need for shielded cable.
- The gray rectangle represents a Velleman K4700 speaker protection kit
- Both banana plugs and Neutrik Speakon connectors will be in that big space above the Velleman unit and transformer.