Thanks gents - I didn't understand some of the more technical bits above but I think I could follow the steps below -
Shield the foils just incase I'm ever in an earthquake scenario.
Test the output per box on an old driver. I assume there's no chance of damaging an amplifier by turning it on with no load on the output?
I will indeed mark up the outputs to make it clear which is which... Until that's done I can tell by picking them up - the mid unit is about 10 times heavier!
Shield the foils just incase I'm ever in an earthquake scenario.
Test the output per box on an old driver. I assume there's no chance of damaging an amplifier by turning it on with no load on the output?
I will indeed mark up the outputs to make it clear which is which... Until that's done I can tell by picking them up - the mid unit is about 10 times heavier!