Ponty
pfm Member
A bit of a strange one. Our Siemens dishwasher (about 12 years old) drains but leaves a small amount of water sitting in the filter housing, only visible if you remove the filter access cover. Unless I sponge this out before using the dishwasher again, it will start the program then stop with the water warning light on. The filter and impeller are clean as a whistle. The pump obviously works otherwise the program wouldn’t run and there would be loads of water left in the bottom. I’ve tried googling the issue but only comes up with blocked filter etc, which it isn’t. I’m thinking it could be a sensor of some sort. Any ideas? Thanks!