claire.foxx
-⃝⃤
Got me a Merg Perdigee super cheap, am thinking of doing it up and selling it as small profit for my time and then ploughing the profits into something more bass related.
First up, what’s good for removing matte spray on the back? The logo is under there but it’s been sprayed over (fortunately not the serial).
The print work underneath is intact and I can get it off slowly with wire wool but I don’t want to risk taking off text or print... the synth inside is in good condition and unmolested And the key contacts are all good knob travel feels just right... (not too gummy) but before I sell it I want to get the casework and woods off and restored again, a minimal fixer-upper.
White spirit does nothing. Abrading gets a little further but it’s hellish hard to gauge if it will be ok in the long run.
I think I recall from GOLT that acetone attacks the white print that Moog used so that’s a no no...
First up, what’s good for removing matte spray on the back? The logo is under there but it’s been sprayed over (fortunately not the serial).
The print work underneath is intact and I can get it off slowly with wire wool but I don’t want to risk taking off text or print... the synth inside is in good condition and unmolested And the key contacts are all good knob travel feels just right... (not too gummy) but before I sell it I want to get the casework and woods off and restored again, a minimal fixer-upper.
White spirit does nothing. Abrading gets a little further but it’s hellish hard to gauge if it will be ok in the long run.
I think I recall from GOLT that acetone attacks the white print that Moog used so that’s a no no...