garyi
leave blank
I have one of these new fangled ring door bells installed this week, one step closer to being taken over by the IOT.
I got it from a carbooty so the battery is a bit crap so I got a plug in power supply for it which works, however the power supply is very warm to the touch which concerns me.
I was instead going to buy this:
https://www.screwfix.com/p/british-general-8-24v-8-va-bell-transformer-module/8707p
and inclose it in this:
https://www.screwfix.com/p/wylex-ese2-ip40-2-module-unpopulated-din-enclosure/32311
But basically was going to put it on a plug, as its no where near the consumer unit, I cannot find anywhere if I can or cannot do this, any thoughts?
I got it from a carbooty so the battery is a bit crap so I got a plug in power supply for it which works, however the power supply is very warm to the touch which concerns me.
I was instead going to buy this:
https://www.screwfix.com/p/british-general-8-24v-8-va-bell-transformer-module/8707p
and inclose it in this:
https://www.screwfix.com/p/wylex-ese2-ip40-2-module-unpopulated-din-enclosure/32311
But basically was going to put it on a plug, as its no where near the consumer unit, I cannot find anywhere if I can or cannot do this, any thoughts?