andy831
pfm Member
My new loudspeakers have arrived and it seems very likely that I am going to need a much more powerful Valve amp than I presently use.
I am not "gifted" practically, in fact I am a complete novice when it comes to the soldering iron. I can however read plans and therefore assume I could read a circuit diagram.
Having looked inside several point to point wired set amps with no circuit boards, the internal Architecture does seem very simple, or am I over simplifying what i think I can see???
I am therefore considering maybe building an 845 Architecture Set amp to maybe give me 50watts plus per channel.
If I was to attempt this, I assume I would be better off with a "Kit" of some kind. Can anybody suggest a suitable manufacturer so I can start to browse.
Being a complete novice if you think this is a bad idea then please say so, as I would hate to buy, make a start and find it completely beyond my capability to complete the project.
I am not "gifted" practically, in fact I am a complete novice when it comes to the soldering iron. I can however read plans and therefore assume I could read a circuit diagram.
Having looked inside several point to point wired set amps with no circuit boards, the internal Architecture does seem very simple, or am I over simplifying what i think I can see???
I am therefore considering maybe building an 845 Architecture Set amp to maybe give me 50watts plus per channel.
If I was to attempt this, I assume I would be better off with a "Kit" of some kind. Can anybody suggest a suitable manufacturer so I can start to browse.
Being a complete novice if you think this is a bad idea then please say so, as I would hate to buy, make a start and find it completely beyond my capability to complete the project.