Recent content by Vintagebarry

Thanks for the interest. I could show you pictures but didn't know how to on here?

I have this on the end of a alpherson opel arm on a thorens td150 Mk2. carnt find much about it. I wanna sell it all!!

So if I was to change the interior wireing with a high silver content would that be too far from the original. A Jaguar E type for e.g. if I was to fill the tank with a higher combusting fuel, still original right. My kreping the originality of the speakers is to maintain spec, parts on...

Impeccable sarcasm, well done. So your question is what exactly? So I will make all internal joints air tight with some kind of silicone/bonding try to smoothen of the right angles. Need to clean the tweeters, the old ferrofluid gunk must have been why they stopped working. I will give...

Hello. I have read that the mission 737r has the most up to date woffer of the same 770's. Can I just replace into 770 speakers without any issue regarding the crossover? At the moment crossover is working. The h211 seas tweeter has dried and doesn't work so I am using some small middy system...

Thanks, all he spouted was negative and suggested nothing positive at all. Came across quite condescending, assuming I knew nothing at all regarding hifi. So the Sonatas im going leave them how they were, I spent a couple of hours messing around with the speakers and moving other bits of...

You can have them if you like. .swap me something for them?

Sounds expensive! Sonatas are laying around doing nothing wanted a purpose for them. .I had nothing to do so had s mess around. .we'll see doffo not chucking them out! I was a collector of vintage hifi, got forced/nagged to sell it off. Started to add onto the equipment I kept naw adding bit...

Results Thay work, first time had sound through them for say 20 years dunno. Got some sort of rattle inside so will have to tie everything down. Maybe I should send the tweeter back home to its original cab. Could I leave this hole for the tweeter in the JPW open, get some plumbing plastic...

Ok just around the sides and back then. Not pack it in densely is that what your saying? I think the tweeter will be fine, im not aiming for giant killer speakers just something nice. It was reading posts that you commented on regarding this exact topic, The Sonatas. .

Its a resistor 2.7 I can see from the kenwood and in the JPW is more of a proper crossover more complex. I will give it a go anyway. Dampening material is more or less better. And where to fill the material? Arround the sides or back or all over at what density loose or packed? Thanks

Thanks, iv got better speakers, much better. The bitumen sheets ok thanks for that. I don't wanna go buying anything for them just making use of what I got, any household material you can think of. I noticed the cables inside the cab my brother changed for thick speaker cable. Is that good...

Hello everybody, It's me Barry again! I was wondering around the forums and saw many people who juggested there is room for improvements. My pair bought by my brother in his uni days almost 30 years ago, tweeters have been replaced twice because they very easily fail so they are shot! But...

I was thinking about the celestion ditton 15 range. Pretty underrated good speakers at very reasonable prices.