So on the S variant the input cap/resistor combination is 6n8/470R. Simply change those two to 1n/560R - job done.
For a significant upgrade use a 0.1% Naked Z-foil resistor. And while you are in there replace the tantalum caps too - same values just a good reliable brand such as Kemet.
I hand etched & cut a pair of boards years ago but don't recall what happened to them now. Tried all sorts of resistor/cap combinations but never found them to truly deliver what I was looking for. I seem to recall that I might have posted something here because I made up and small acrylic...
Pics would help because I don't recall that 33R is a standard item. The NAP110 takes its 24v preamp supply off the main bridge rectifier AC feeds and then routes that to feed the AC voltage to a smaller rectifier mounted directly on top of the 3300uF/40v cap. The positive and negative...
Sorry I'm a bit late on this one (not around here as much as I used to be). But I have seen (and heard) rooms that need a balance pot to correct for some acoustical imbalances. If yours in one then removing the balance pot may not be your best solution. In which case at 2 O'Clock the balance pot...
As it happens I only recently acquired a NAP 150/NAC 112 pair - listed as non working and in mint condition with original cartons...a bargain price too. The only faults I could find on either piece were a leaking reservoir cap and a dead LM317. Once both were replaced normal operation was...
IIRC, the Naim 5 series have have a single primary transformer and must be replaced rather than rewired as is the practice with most Naim transformers. Call or email Salisbury...
Thanks for the info guys, most helpful. And they are readily available over here too, Madisound (being the US equivalent of Wilmslow) have them at about $75 each
A friend of mine has blown the tweeters in a pair of Allaes...we are looking for replacements but can find no info on the web as to what they are. Does anyone now or if there are any issues with DIY replacement - I have read that there is some sort of suspension mount but no details of it.
Many...
Just to confirm the cards will fit the 72, the 729 pin difference being as described, The fifth pin is the 32/32.5 specific mono blend facility that is not featured in the 72
"NJ"
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.