gerlando
Prog Rocker
Hello there,
sorry, I have just acquired a Systemdek IIX 900 with Audio Note acrylic platter upgrade.
Unfortunately the belt slips off and under the turntable wheel when set to 45rpm.
I have tried to adjust the suspension bolts for lowering the platter, with no results. With the platter on its lower limit, the belt is coming off from the lower side of the sub-platter.
Maybe this can be due to the larger thickness of the AN platter? Or maybe the AN platter is lighter than the original one?
I also tried to adjust the bolt for setting the angle of the motor assembly, but I didn't notice any significant improvement.
The platter starts to turn at 45 rpm, then after few seconds begins to swing, then it stops (belt fell off).
Could anyone help me please?
Many thanks in advance for the suggestions.
Mauro
sorry, I have just acquired a Systemdek IIX 900 with Audio Note acrylic platter upgrade.
Unfortunately the belt slips off and under the turntable wheel when set to 45rpm.
I have tried to adjust the suspension bolts for lowering the platter, with no results. With the platter on its lower limit, the belt is coming off from the lower side of the sub-platter.
Maybe this can be due to the larger thickness of the AN platter? Or maybe the AN platter is lighter than the original one?
I also tried to adjust the bolt for setting the angle of the motor assembly, but I didn't notice any significant improvement.
The platter starts to turn at 45 rpm, then after few seconds begins to swing, then it stops (belt fell off).
Could anyone help me please?
Many thanks in advance for the suggestions.
Mauro