Recent content by kropo

Hi Anyone tried these hicap clones? http://rover.ebay.com/rover/1/710-53481-19255-0/1?icep_ff3=2&toolid=10001&campid=5338728743&icep_item=131572466441 Jake

Hi Any boards or advices where to check power supply for Maxon 226774? I was thinking maybe try this on LP12. How about speed controller? Is that in power supply or different board? Regards Jake

Hi Now solved. I got tip on another forum. I changed 5pin to 5pin cable between hicap and nac202, also tightened bolt from cable between Nap and Hicap. Thanks. Regards Jake

Hi I hope you guys have some points where to look. Yesterday my Nac202 was making some crackiling noise (like unplugging rca cables) and it made it even on muted. Okay, it start to make that noice again and I was looking cables and touched/moved power cable and then it makes bigger crackling...

Hi Thanks, yes the finger lift is temporary, this arm is not going to stay at this setup long time. I'm building another turntable to that arm. I noticed yeasterday that this kind of "big/long" finger lift is much harder to use than smaller one, needs to change that. On the list is: 1...

Hi I looked this topic and I ended up with the result that I need to make another one with arrow as arm tube. My DIY Aro was made of aluminium and steel. Counterweight, "pivot stick" plus bearing assembly and arm cup pivot was made from steel, other parts are made from aluminium. This thread...

Hi Of course I'll share if I got something to share. I haven't follow this thread but I'll read this and post my thoughts. :) Regards Jake

Hi Not bad at all. :) I don't have original Aro to benchmark but I have Rega RB300. Some adjustments need to set but at this point this one sounds good. Regards Jake

Hi Sorry for loaning topic. I almost finished my first DIY Naim Aro Look-A-Like today. I had problems with counterweight so finally it got kind of ugly. :) But at least now I can finally listen NOFX. ;) Pictures: Regards Jake

Hi Cable threads always end up fighting. :) I have this Mogami cable also and I was thinking to make couple of cables. Any suggestions to DIN plug for Linn tonearms? Regards Jake

Hi I was just last night thinking about Radikal motor enclosure and is there any improvement to enclosure normal LP12 motor with same kind style? Regards Jake

Hi Thanks a lot John! Regards Jake

Hi John I send you PM (I hope you got it). This thread is just what I was going to make myself. :) Man needs he's projects.. Also if someone knows how much it should weight (sub chassis + arm board), that info would be nice. Thanks. Regards Jake

Hi That gives me idea to built integrated amp. I have Nac42.5 clone done so maybe these Nap140 clone board would suit there nicely.. :) Jake

Hi Thanks Rob400! :) Jake