Flyingorthopod
Active Member
Sorry for another TD150 related question. Grateful for advice.
Deck is with a very helpful local shop for service. Springs are sorted. However he has pointed out that the RB300 I had fitted 25 odd years ago isn't quite at the right position - the spindle to pivot distance is about 7mm out. This may have been deliberate to help the arm clear the lid. AFAICR the armboard was off the shelf at the time of changing.
It sounds pretty good to me but could probably be improved!
He's offered a free swap to Linn Basik or to change the board for correct mounting.
Or I could ignore it.
What would the forum wisdom do?
Deck is with a very helpful local shop for service. Springs are sorted. However he has pointed out that the RB300 I had fitted 25 odd years ago isn't quite at the right position - the spindle to pivot distance is about 7mm out. This may have been deliberate to help the arm clear the lid. AFAICR the armboard was off the shelf at the time of changing.
It sounds pretty good to me but could probably be improved!
He's offered a free swap to Linn Basik or to change the board for correct mounting.
Or I could ignore it.
What would the forum wisdom do?