Sbooster power supply to Mytek Brooklyn dac...not working.

[BrianPK]

I’ve had to disconnect my Sbooster power supply from my Brooklyn dac as it has stopped working.It makes an effort to power the dac(the light on the dac flashes momentarily)but fails to continue powering.
I’ve disconnected the Sbooster and the dac works away perfectly on it’s own.I suspect the White DC tip is faulty due to cable strain but am not certain.
I presume I cannot use any of the other coloured DC tIps which came with the Sbooster?
Can anyone kindly direct me to an Amazon or eBay site for the correct replacement DC tip as I don’t want to cause damage by fitting an incorrect tip.

 

[sq225917]

It's either.5mm with 2.1mm tip or same barrel with 2.5mm tip.

Just buy one of each size of these type.

https://futurehousestore.co.uk/led-strip-accessories/21mm-x-55mm-male-dc-power-connector.html

They'll be on ebay for a couple of quid each.

 

[BrianPK]

Many thanks for the reply and suggestion.
But that looks very different from mine which has two pins and looks quite similar to below

https://www.ebay.co.uk/itm/40139448...d=link&campid=5338728743&toolid=20001&mkevt=1

 

[BrianPK]

Problem solved.
So,armed with the above dimensions,I finally found this DC tip on eBay.
https://www.ebay.ie/itm/142804700940
it works perfectly and the angled pins take the strain off the cable
It’s been months since I last heard the sBooster connected to the Mytek dac and the sound without it was so good I wasn’t in any hurry to rectify the fault ,but now that it is working again,I immediately became aware of the added refinement and smoothness as the sBooster noticeably reduces any grit and hardness in the sound.
I’m very pleased with myself.
Thanks again.