Replacement Binding Posts / Terminals on an Amplifier - Help identify please.

[Copperjacket]

My ocd has just led me to snap a speaker binding post on an amplifier - I noticed it was bent so rather than leave it alone, I had to straighten it with the inevitable result!

The terminals are a block of 4 posts ie left and right set in a plastic Block. Dimensions are 3" x 1" and the terminalss are at 3/4" centres. The terminals will acceptbanana plugs from the top or cable through the side. the plastic finger nuts are round and crenellated Sorry I can't post a picture at present - problems with photobucket.

Does this ring any bells please?

Many thanks

 

[Copperjacket]

Terminals are the same as these: borrowed from a completed sale thread on here - I hope that is acceptable?:
https://fatmanamp.shutterfly.com/pictures/11

 

[James Evans]

Do a google image search for "cliff electronics binding post" and see if any of those match.

 

[John_73]

These the ones?

https://cpc.farnell.com/cliff-elect...MI-7q1zfid4gIVBKQYCh3DfghOEAQYByABEgLEJPD_BwE

 

[Copperjacket]

Thank you both very much - they look right. Is it likely I will be able to unsolderand unbolt one and replace it?

 

[John_73]

You’ll likely need a reasonably powerful iron (40W) to get the wires unsoldered as quickly as possible to avoid melting their insulation, unless (fingers crossed) the cable was soldered to an eyelet/lug in which case you’d just unscrew and replace. Good luck!

 

[Copperjacket]

Thank you John I will give it a go. at least I now have an idea of potential problems.

 

[bugbear]

(can I just commend all involved in this little thread? Wonderful!)

BugBear