Amber Audio
This is the Day
Last edited:
Thank you for that. I think the Y splitter would be necessary to get the information from both channels on the amp. I spoke with the dealer and wholesaler for my amp and they strongly advised against using the speaker connection for my amp (a Moon 340) as they think there is the possibility of damage to the amp. They saw no problem with the RCA connection though. I will reflect and think about this.You connect L or R from the amplifier out to the Low Level input on the REL.
or
Use a Y splitter.
or
The best way according to REL is to use the High level speakon to 3 wire cable method.
If your amp is Class D then you need to cable things up in a specific way.
Good info here
Yes, but since that connects back to the amp through the speaker cables, I’d rather not given what the dealer says. But the RCA would OK, either Y or single. (I wasn’t aware that it’s mostly mono so single is OK).Most sub info is mono so a single RCA to RCA does the job, but to be 100% using a Y splitter is a common solution.
You can use the High Level cable connected at the speaker terminal end rather than the amp end by stripping it from the sheath, I used to do it that way when using a Naim amp into ProAc Studio + REL Strata.