LP12 lid rubber cushions

[1964meb]

Hello fishes

Can anyone tell me where I can get a couple of those tiny, fiddly cushion feet for the front corners of my lp12 lid please? My ones are a bit squashed

Ta in advance


Mike

 

[deebster]

Don't know about original ones but some simple anti-vibration pads would work maybe?

RS components have lots of that sort of thing.

 

[misterc6]

http://rover.ebay.com/rover/1/710-5...0001&campid=5338728743&icep_item=264312013537

 

[david ellwood]

Or just walk into a decent dealers and get some given.

 

[hp1]

I dont bother with them as they only last 5 minutes. I use a small blob of polyurethane sealer as used in the motor trade for sealiing new panels ,trims etc.

 

[david ellwood]

My set are just needing changing after fifteen years.

 

[stevec67]

Don't bother. I never did, sounded fine without.

 

[guydarryl]

Or just walk into a decent dealers and get some given.

Did this about 10 years ago. Clean out the small locating hole in lid and and use a tiny drop of superglue. Just checked and they are coming up for replacement.

 

[hp1]

I think the life of them is down to how you open the lid , if you lift it evenly from both sides they last much longer, I always lift from one side and they seem to disintergrate. also a bit of polish stops them sticking to the wood.