martin dawson
pfm Member
Does anyone have the dimensions for the hole size and position for fitting the Aromatic arm lift to the Linn / Aro arm board please?
Regards,
Martin
Regards,
Martin
Linn / Aro arm board for LP 12
- Thread starter martin dawson
- Start date
YNWOAN
100% Analogue
OK, a 12.5mm diameter hole - the centre of which is 25mm from the right hand edge of the armboard and 99mm from the top edge (the one nearest the arm pillar).
These measurements are from one of my own drawings but I've got the actual Naim one at my home - will double check tonight.
These measurements are from one of my own drawings but I've got the actual Naim one at my home - will double check tonight.
martin dawson
pfm Member
Many thanks Mark,
Much appreciated.
Regards,
Martin
Much appreciated.
Regards,
Martin
YNWOAN
100% Analogue
Sorry Martin, I've had a look on my home PC and I can't seem to find that particular Naim file. However, the dimensions I gave earlier should be correct (the RubiKon was made with them a at least two Aromatics were fitted). If you want a drilling template making drop me a line and I'll do one for you 
.
.