Hello,
Fine!
Can you give the new link of tinkerkad with the upgrade
Hello Sean,
Yes, your design of the CB knob on thinkercad, if it's possible
I want to print the design on Professional printer
Thanks very much
Theses look fantastic. Have you decided to put them to market yet? I’m sure you will have lots of interested parties if you did. Excellent job.I also made some CB knobs a while ago. Also made with Tinkercad, and I printed them on an Elegoo Mars 2 SLA printer. I'm pretty happy with the results, the photos make them look slightly translucent but this isn't obvious in real life. All the units below are using my prints apart from the NAP 140, which is the original.