nojobtoosimple
Active Member
Hi all,
I have been reading through threads about ALWSRs and TeddyRegs/STRs with a view to understanding the categorisation of output impedance levels for regulator solutions. Can anyone tell me the sort of values at which output impedance would be considered to be high, low, very-low or ultra-low.
I seems likely that output impedance is frequency dependent (many parameters seem to be so in the real world) in which case are there particular frequencies at which output impedance is described to enable comparison ?
I expect this sort of question is easier asked than answered but I'd be grateful for any information, however 'wooly' it may seem to a proper engineer.
Thanks, in anticipation, for any help.
Regards,
Jon
I have been reading through threads about ALWSRs and TeddyRegs/STRs with a view to understanding the categorisation of output impedance levels for regulator solutions. Can anyone tell me the sort of values at which output impedance would be considered to be high, low, very-low or ultra-low.
I seems likely that output impedance is frequency dependent (many parameters seem to be so in the real world) in which case are there particular frequencies at which output impedance is described to enable comparison ?
I expect this sort of question is easier asked than answered but I'd be grateful for any information, however 'wooly' it may seem to a proper engineer.
Thanks, in anticipation, for any help.
Regards,
Jon