vintageaxeman
Active Member
I've been checking out a pair of active speakers where the 3 drive units (in each) are almost bonded in position, they are that tightly installed. A such it would be difficult to get inside to check the wiring and speaker / amp connections.
My problem is this...I used a non-specific system setup CD the other day to test the system out, and while I was doing so, I reached a possible problem on regarding phase. The speakers in question have built-in active crossovers and power amps. When I tried the 'phase check' track of the CD, the sound 'image' was NOT as centralised as I expected it to be.
I have not been able to find out whether there is any way to check each individual drive unit to see whether each pair are in phase, other than by dismantling it.
Any ideas please, folks?
My problem is this...I used a non-specific system setup CD the other day to test the system out, and while I was doing so, I reached a possible problem on regarding phase. The speakers in question have built-in active crossovers and power amps. When I tried the 'phase check' track of the CD, the sound 'image' was NOT as centralised as I expected it to be.
I have not been able to find out whether there is any way to check each individual drive unit to see whether each pair are in phase, other than by dismantling it.
Any ideas please, folks?