Richard Lines
pfm Member
Good afternoon all,
Next up is the pair of NCC200v1.5 PCB's that were fitted to my 'Voyager' NCC200 amplifier and now longer used. Note they are fitted with the BUV20 output devices, low noise resistors in the feedback and signal paths and an 86uF wet tantalum capacitor.
I'm looking for £120 the pair + P&P at cost.
Regards
Richard
Next up is the pair of NCC200v1.5 PCB's that were fitted to my 'Voyager' NCC200 amplifier and now longer used. Note they are fitted with the BUV20 output devices, low noise resistors in the feedback and signal paths and an 86uF wet tantalum capacitor.
I'm looking for £120 the pair + P&P at cost.
Regards
Richard