Yep I've now got LEDs on the output cap boards to warn me they're powered up and a big 10 watt resistor with flying leads to short across the rails to discharge each side once I've finished any adjustments )
60mV should be fine I reckon.
Hi, I am looking at adding front end hackernap regulation to my ncc200 boards.
They are being built on veroboard and I was wondering whether I could relocate C9 and 11 off the amplifier board and onto the regulator board.
It will allow me to use a film capacitor I have in stock.
I have some 1uF polystyrenes begging to go into this build but I guess they are a bit small in value for they key locations.
Cheers Andy.
Have spotted that on the how to wire it all up diagram in build manual 1.4, some of the wires go to terminal positions that do not match the actual PCB. Bit confusing.