One of my amps has developed a problem with the volume pot and have been quoted a wide variation for the job with the distributor being about 5x the cost of the cheapest , so how much would you expect to pay ?
And I bought one! But it has a weird log slope.Depends on how much the pot costs and how hard it is to replace the pot.
A highly regarded TKD 2CP-2511 costs over £80 from Hificollective but the Alp blue beauty is only £14.
The volume pot in my Onix is connected with flying leads, so it'ss easy to unbolt and replace. Some are soldered to a pcb and removing the pcb can be a real pain.
And I bought one! But it has a weird log slope.
But I think the OP is asking how much the work should cost.
I'll PM you.What do you mean?
I just ordered one today
I'll PM you.
I have the correct volume pot from the manufacturer so that cost is paid , it just needs to be fitted . the old one does need to be removed from a pcb and the new soldered back into place
I have the correct volume pot from the manufacturer so that cost is paid , it just needs to be fitted . the old one does need to be removed from a pcb and the new soldered back into place
Shouldn't cost much to swap it over, 10 minutes at most -
Assuming you already have the amp apart and the PCB removed to work on.
Then of course you have to test it and re assemble.
If you can do all that in 10 minutes I have a pile of jobs for you
Since we do not know what make of amp we are talking about..it hard to advice further.