Quad II interconnects

[naimplayer]

I have just obtained a pair of Quad II valve amps. I need to buy/make interconnects for these. Initially I am going to try using my NAP 52 until I can get a suitable valve pre. Any helpful suggestions/advice will be welcomed. I found an old wiring diagram which I can just about read. If you have a valve pre that needs a new home that may be compatible please contact me.
Thanks in anticipation.

 

[Barrymagrec]

As you will have realised the quad uses a single 6 way Painton / Jones connector for input and power to the preamp. Assuming you can source the correct connector just connect a length of decent screened cable to the appropriate pins and put a Phono connector on the end. For both amps. Don`t get the connection wrong though, your NAP may not appreciate 300 volts up it.
If you look about you may find somebody already does something along these lines.

 

[Barrymagrec]

For instance - http://rover.ebay.com/rover/1/710-5...0001&campid=5338728743&icep_item=110932333782

 

[statman308]

Flashback also sell interconnects for Quad II amps. Their site doesn't list one specifically for connecting up to a Naim preamp but I'm sure they can make one up for you.

http://www.flashbacksales.co.uk/acatalog/quadii-cables-and-adaptors.html