MrPinkEyes
Come on Pooh
Naturally if you do this to your own speakers and things turn to custard its on your head. Though i would fine it hard how that could happen, but if it can happen it has happen.
This was sent to me from Naim. Hope it can get them sounding at their best.
Bass driver Torque to 4nm then back off and re-torque at 3nm. These must be done criss cross like a car wheel i.e. bolt at 12o’clock then bolt at 6o’clock and so on.
BMR 2nm following the same method of criss crossing.
Crossover to plinth is 2.5nm.
Plinth to cabinet 2x bolt at front are 3.6nm, leaf spring to cabinet 4x bolt centre back are 2.5nm, leaf spring to plinth 2x bolt back left and right 3.6nm.
This was sent to me from Naim. Hope it can get them sounding at their best.
Bass driver Torque to 4nm then back off and re-torque at 3nm. These must be done criss cross like a car wheel i.e. bolt at 12o’clock then bolt at 6o’clock and so on.
BMR 2nm following the same method of criss crossing.
Crossover to plinth is 2.5nm.
Plinth to cabinet 2x bolt at front are 3.6nm, leaf spring to cabinet 4x bolt centre back are 2.5nm, leaf spring to plinth 2x bolt back left and right 3.6nm.