advertisement


Naim pre amp supply on Supernait 2

G

grant harris

Member
I am currently using a Naim Supernait 2 with a Flatcap 2X, the reason for this is that I use an external Dirac device for room equalisation.
Can I disconnect the 24V line from the 5 pin snaic and either take the 24V feed from aux 2 or am I correct that the NC pin on the power amp socket should be connected as this seems to be connected on the blanking plug.

if I could do this then I wouldn’t need the Flatcap 2X

Any thoughts as I know I cannot ask this question on Naims own forums.
 
I don't really understand the question?...though possibly others do...

The supernait doesn't need a flatcap to work...infact it might even be detrimental to its performance (I hate the FC as a power supply)
For me at least, you will have to explain the issue further so I can understand it
Also ...The x2 has two outputs on the back that each supply 24v ...doesn't it?
 
I needed to take the pre amp out into a Dirac room equaliser and then take the power amp feed from the Dirac unit back into the power section of the Supernait 2.
The only way to do that is to use the Flatcap so I don’t really need it to power the preamp section only to allow me to insert the Dirac unit between pre and power.
 
You could have a custom cable made up to do that without supplying the power as well

Maybe CHC could help with that
 
You must log in or register to reply here.


advertisement


Back
Top