1000RPM
pfm Member
My 2215b receiver has a fault...
when the tape monitor or loudness buttons are pressed, the unit sometimes loses signal in one or both channels. I figure either the switches are dirty or knackered, or it might point to some component failure in the tape/loudness circuits.
Any advice or recommendations on how/where I can get it looked at?
thanks all
when the tape monitor or loudness buttons are pressed, the unit sometimes loses signal in one or both channels. I figure either the switches are dirty or knackered, or it might point to some component failure in the tape/loudness circuits.
Any advice or recommendations on how/where I can get it looked at?
thanks all