im going to fit my ancient Lockwood serviced HPD Tannoys into corner cabs... i have those sorted but ruined the baffle cut.Not GRF design but with echoes.
I would also like to rebate the chassis into 3/4 particle board. in their original lancaster cabs the baffle hole was notable smaller than the chassis... circa 1/2" in front of cone all round.I expect to thicken the front baffle to provide more depth to assist the rebate.
Are there CNC or older plans available suitable for modern baffle cutting.
I havent looked on the Troelsgarden site yet
I would also like to rebate the chassis into 3/4 particle board. in their original lancaster cabs the baffle hole was notable smaller than the chassis... circa 1/2" in front of cone all round.I expect to thicken the front baffle to provide more depth to assist the rebate.
Are there CNC or older plans available suitable for modern baffle cutting.
I havent looked on the Troelsgarden site yet