JST BVH-21T-P1.1 Loose Contact For VH Series
Order code: 22-5306
JST VHR-3N 3 Pole Housing VH Series P3.96 mm
Order code: 22-5272
JST BXH-001T-P0.6 Loose Contact XH Series
Order code: 22-5374
JST PHR-4 4 Pole Housing PH Series P2.00mm
Order code: 22-5244
JST VHR-2N 2 Pole Housing VH Series P3.96 mm
Order code: 22-5270
JST BPH-002T-P0.5S Loose Contact For PH Series
Order code: 22-5254
Is what I ordered, I used a 4 pole connector for the signal in.
Pete
Looking a bit fuller now...My Ice power module in a Cisco DMP case, we chucked out lots of these so I grabbed a couple and found a Transcend 4gb 266X Compact flash card inside, that in the camera now!
B&O ice power by Pete Maddex, on Flickr
Pete
Just an a amplifiered capacitor to filter any crap from the onboard supply.I was wondering what the transistors were for ( like on the B4 buffer )is it some sort of a soft start ?
i used a relay to pull down the enable pin (pin 7 ) the relay open after 5 seconds on power up stopping any pops