kwmason
Won Ton On
Hi All,
my first post on the classic thread but i thought its about time i started a project rather than collecting them and never making a start (long story but i had a fire at work and lost my collection of turntables to build).
One of the turntables was a TD124 - 2 days after the fire a new plinth arrived that i'd previously ordered and despite the TT being destroyed I thought, ah it's an omen. At least i should get another - so i did
So here i am about to assemble a TD124.
irst question.
The plinth i have bought is a deep ply construction with long holes for the mounting bolts. the rubbers with the mounting bolts fit snuggly but I'm assuming i need the appropriate nuts to tighten these up? But based on the design of plinth i have it would just we squeezing the rubber tight to grip the hole - is that correct?
my first post on the classic thread but i thought its about time i started a project rather than collecting them and never making a start (long story but i had a fire at work and lost my collection of turntables to build).
One of the turntables was a TD124 - 2 days after the fire a new plinth arrived that i'd previously ordered and despite the TT being destroyed I thought, ah it's an omen. At least i should get another - so i did
So here i am about to assemble a TD124.
irst question.
The plinth i have bought is a deep ply construction with long holes for the mounting bolts. the rubbers with the mounting bolts fit snuggly but I'm assuming i need the appropriate nuts to tighten these up? But based on the design of plinth i have it would just we squeezing the rubber tight to grip the hole - is that correct?