Recent content by Zombie

I have probably done smth wrong :)

it goes bonkers when I add a 24 Ohm resistor in parallel on each speaker

I can change it if I have an impedance file.

Can't change speaker impedance in Xsim it seems.

Haven't found any simple way to calculate the xover frequency properly as most online calculators use the same standard values and the same order. My xover is a 2nd order LP and 3rd order HP. Any hints?

df_genius on this forum serviced mine.

How do one replace the ferrofluid?

Bring out the garlic and silver bullets, someone is actually checking the facts!

Are Tidal favourites integrated into the the local library view or do you neeed to access Tidal specifically?

Is it possible to control this through LMS? I think A6 was...

Just start a cable thread and say smth provocative and you're at 50 posts in no time

Checking interest for my recently refurbed 988s. Fabolous sound. Please note that they are located in the EU. Original boxes, but risk is on the buyer's side. Enquiries only through PM.

The AP-22ES is actually quite good. I've got freshly refurbed ESL-988s behind them to compare with. ;) I did a primitive measurement with REW and could replicate the 3rd harmonic distorsion around 1 kHz, but no trace of the breakup in the waterfall. This can mean two things, my waterfall is...

I just wonder what effect it'll have to replace the coils. The 3rd harmonic distortion around 1 kHz is supposed to come from smth called cone breakup of the bass speaker. APM-22ES distortion How can this be remedied or made lower in a simple way? Are the coils involved in the speaker distortion...

Thank you for the advice. The coils are positioned like you describe. One is a BLM, German made I think, quite heavy, but probably not iron core, the other one is a smaller air core and is standing on its side. HP is third order, while LP is second order. I ordered Standard Z caps for the HP and...