advertisement


Recent content by Tim in Seattle

  1. T

    It's time for the Ergo IIIR

    C,
  2. T

    XS integrated loose front end, how to open?

    thank you everyone, i found the plug in the bottom center and pulled it out and was able to tighten up a hex/allen screw deep into the chassis and get the front panel much tighter, not perfect but much much better.
  3. T

    XS integrated loose front end, how to open?

    thank you, i will look for the small hole, i may have seen the plugged hole, i thought it was a rivet. Hopefully i can pop that out and tighten it up. my concern with the pictures is it looks like the top of the case comes off and leaves the bottom and front panel, but appears that possibly...
  4. T

    XS integrated loose front end, how to open?

    I have a nait XS that has a wobbly front panel that just seems to need some tightening up, but i am not quite sure how to open the case up and would prefer not to break anything inside to do a "cosmetic" repair. There are screws near the feet in each corner of the chassis and then a line of...
  5. T

    Spendor SP1/2

    i could send it to you, it is a PDF, can't figure out how to attach....
  6. T

    Spendor SP1/2

    the crossover schematic is available on the spendor yahoo group files page. i have a pair of these so, will be curious what you come up with and would love to hear any opinions on how the wire or xover component changes may tweak these up?


advertisement


Back
Top