advertisement


Recent content by say it as it is

  1. S

    Ruark speakers

    Old post alert lol Well had a pair Templar now for a while on the end of a Nait XS seem to work nicely not huge bass or piercing treble but generally just right sounding and fun
  2. S

    DIY fix for broken Naim CDX - laser unit I think

    Ok rules out the door switch then if getting as far as error message. Other thing to check are the sliders free to move the plastic gears can slip or the carriage not slide freely on the rails. But not spinning at all sorry not had that fault
  3. S

    Suggestions for a BBC style monitor, budget £500

    I had Rogers LS6 found then a bit dull not as much bass as expected tbh
  4. S

    DIY fix for broken Naim CDX - laser unit I think

    Is the cd spinning at all can you hear? Nothing as simple as bad door switch or the like?
  5. S

    Nait

    The XS is a lot for the money sounds decent on it own but can take a hicap or be used as a pre or power amp very flexible. I got mine as a stop gap nearly 2 years later still in use
  6. S

    DIY Speaker Isolators for Wooden Floors

    well might try a 10inch inner tube inflated under the bamboo boards can play about with pressures but given how good a job a pneumatic tyre does at isolation. My other thoughts are sorbothane is well regarded as excellent in engineering for isolating mechanical noise and vibration. 3mm cork...
  7. S

    Which component has the most effect on 'holographic' sound

    well maybe not holographic as such but was quite stunned how much difference a CD player can make, hooked up a player I had given my dad to use for a while Rotel RCD 965 it was amazing how much width and almost 3D effect it can extract from some tracks. To echo previous comments this CD with an...
  8. S

    Avondale SE200 Announcement on FB

    Thanks
  9. S

    DIY Speaker Isolators for Wooden Floors

    I have tried them slightly set back via the spikes I prefer them level but the Ruarks are so small they are on an angled face and project upwards at a slight angle. I have the larger size bubble wrap with bigger air pockets see if that makes a difference to the regular small stuff
  10. S

    Avondale SE200 Announcement on FB

    Are you buying bare boards and populating them or are Avondale selling the completed boards ?
  11. S

    DIY Speaker Isolators for Wooden Floors

    As I have laminate flooring I might try the bubble wrap between my existing bamboo boards and floor.
  12. S

    DIY Speaker Isolators for Wooden Floors

    might try that, thanks
  13. S

    B4 buffer recommended psu

    Following the advice on here I used a 10va 18v transformer into hacker cap board with 4700uf caps and some qspeed diodes I had.
  14. S

    DIY Speaker Isolators for Wooden Floors

    Old thread alert linked to a current conversation I gave up on the granite boards with half bouncy balls, they played havoc with the Naim Intro had for a bit. Very simple now bamboo boards straight onto laminate floor speaker spikes into that. Speakers now Ruark Templar that can occasionally...
  15. S

    Avondale SE200 Announcement on FB

    All this SE talk getting me jealous lol.


advertisement


Back
Top