Recent content by ricardo007

Hallo This thread has not been very successful it seems. There are 6 pins on the balance pot. Where to locate the 2 pairs of resistors and is additional wiring required? Should the balance pot should be removed also? Any picture? Richard

@Martin: thanks for your picture in advance. The poweramp is not with me now but will try to get a more detailed picture this week end. However once I get your picture, I will have the information I need, I will just check the color codes later! As for the change of resistors I was planning...

Hello I have a schematics of a NAP140, supposedly close to the one of the 110: https://drive.google.com/open?id=1MjiPzPyiyPP4U3eLhajXtxZQKoDfN3JRrg and a picture of the inners of my 110: https://drive.google.com/open?id=0B-2wnjd4pojAdzJtV1RqQWJ2THd6cVMzWDVwczJnRUNpNUJz On the...

@dowser I have android LG G4. Can you give me link of the two type of equipment you mentioned since i never heard of that @venton I understand chord mojo is a DAC but output from a smartphone via jack socket is analog isnt it? @Emile Thanks for identifying a cable supplier

Hello Is there any problem to use a smartphone as input to a naim nac42 using either tape or tuner input or one of them preferably? Which custom cable should be used and where to find it? Also, should the length of the cable be long enoug so that the smartphone does not create hum in the...

Hi I read a few mods possible on a Nap 110. First replacing the 47uf tants feedback caps by axial wet tantalum ones, improving sound by keeping warm sound of beads tantalum caps. Anydown side for this? HOW to idenyify which are the 2 feedback caps? On each channel i have 3 yellow tants and...

Hello I want to bypass the pot. I read on this forum that the 10K log pot can be bypassed by using for each channel a 1K resistor in the signal and a 9K resistor to the ground to mimick the pot. I dont want to change the gain here by using 5k 5k resistor here. But not sure how to do it so any...

Does it apply for these products and how?

Very interesting! Thanks a lot. I am interested to know the various options for using these 2 rails! Option 1, yours, separating signal from power. I understand it detracts from Naim orthodoxy (which itself is not catholic...) whose advantage is to put all grounds planes of snaps2 nap110...

Hello Thanks for these very useful answers. I will try the approach suggested by colasblue. I dont understand what you mean by "if i am using an arm lead"??? I have an lp 12 witth a linn tonearm and cable. Richard

Hello I have a snaps modified into snap2. And a nac 42 preamp which i would .like to transform into a 42.5 so that i can take advantage of the dual supply rails feature of the snaps2. Question 1 What does each rail supply power to? Inside the 42 you have 4 circuits : 1- the relay common...

I plan to revitalize vintage audio equipment , namely naim preamp NAC 42 and power amp NAP 110 chrome series + Linn LP12 vintage version revised on which I fit this MC cartridge: https://www.maplatine.com/en/low-output-mc-cartridges/932-ortofon-quintet-blue-mc-cartridge.html The naim 42...