advertisement


Recent content by croak

  1. C

    Quad 306 or 606, which to keep.

    Interesting and I seem to remember something like that. The stuff I hoard isn't trash. I use a Bauer DPS table with Lindemann musicbook pre dac power and audiophysic Tempo. Amongst the nostalgic hoarding Dunlavy SCii Audiophysic Step, Sonus Faber Minuetto and Concertino, the...
  2. C

    Quad 306 or 606, which to keep.

    That's the problem. If it was only these two pieces. The list is too long.
  3. C

    Quad 306 or 606, which to keep.

    I have always been very fond of the 66 system after spending many hours listening to 66/66cd/606 or 306 after hours at the store I worked at as a student. I have always wanted such a set for nostalgic reasons. I obtained a set 66/66CD/FM6/306 some time ago and it is destined for a study or...
    • croak
    • Thread
    • Replies: 30
    • Forum: audio
  4. C

    Mayware formula 4 dimension needed

    I have a formula 4 to repair. The arm tube has come loose from the "pivot ring" and I need to re fit it at the right length. Anyone have an F4 on which they could measure the exposed length of the arm tube from pivot ring to headshell? I am looking for the dimension highlighted in the...
  5. C

    Need your Rega extension advice pink fishers

    I tried it before. If the centre and mains are not from the same series or at least similar the tonal balance can be distracting. Buy a decent enough read speaker and try phantom centre mode for a little first.
  6. C

    Quad CD 66 Player Skipping?

    It all depends on condition and purchase price. There are thousands of Philips machines out there to provide do or parts and I would say overall the cdm4 is the more reliable mechanism vs the cdm9 in the 67.
  7. C

    Phono pre-amp bodge - how do I do this?

    What is the RS part number?
  8. C

    Phono loading plugs

    I measured 1171 ohms and 495mH on a 2m red body.
  9. C

    Phono loading plugs

    http://www.hagtech.com/loading.html
  10. C

    Phono loading plugs

    DIY? You could buy 2 hard rca splitters (1 male 2 female)and 2 rca plugs and 2 110 kilo ohm resistors Solder resistors between pin and ring of the rca plugs. Plug an RCA plug with resistor in to the the hard splinter and connect tonearm to the other half of the hard splitter. Plug the hard...
  11. C

    Cheaper alternative to Tellurium Q Black - Mogami 3103 or 2972?

    TQ Blue very similar to black but deliberately mDe to be a little easier at the top.
  12. C

    Suggestions for classic bookshelf speakers?

    AR SRT170 from early 90s are fun too. M0.5 driven well was quite amazing too for the tot it was.
  13. C

    Rega DAC-R Upgrade advice

    Ok. I get the usefulness in a full Rega or multiple Rega rig and a nice to have. Not sure it would make or break a deal to most though. Thanks for clarifying.
  14. C

    Rega DAC-R Upgrade advice

    Assuming there is no variable volume what useful features are on the DAC R remote unit?
  15. C

    Linn Kan drive units, early models

    Seeing as I had some t27 and b110 from a stripped concerto constructor kit I was saving for ls35a clones. Now they look like this.


advertisement


Back
Top