Nothing to do with me but looks about right:
https://www.ebay.co.uk/itm/175955381560?mkcid=1&mkrid=710-53481-19255-0&siteid=0&campid=5338728743&customid=&toolid=10001&mkevt=1
I’ve a set here that are very rarely used (not least as I sold my headphone amp). Double boxed with manual etc, and original cable little used as I ran them with a 3m balanced (2x3 pin XLR) Cardas clear light cable - also available.
PM’d with offer of photos I’ve grabbed just now of headphones...
This. c.30mm diameter, drill, thread and part off as you go. Polish to a fine finish if desired, heck you could get them anodised or chromed if desired. An awful lot easier to work with than stainless. Unfortunately my lathe doesn’t have a sufficiently large spindle.
IXO just listed on the ‘Bay (NTDWM)
https://www.ebay.co.uk/itm/275966245091?mkcid=1&mkrid=710-53481-19255-0&siteid=0&customid=link&campid=5338728743&toolid=20001&mkevt=1
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.