Good idea. I have dropped a few dabs of the paint on a bit of plastic and will compare after it has dried. The 301 I question is a very late serial number (81k) and has been sheltered from UV all its life so paint is very nice and prob easier to match than a much older deck.
Just went to my local hobby shop and picked up a small tin of Humbol enamel gloss #41, looks like it could be a match.
I was thinking the same, mask it off and use tooth-pick to fill in the chip. Think I was lucky as it is quite small. When I did it I couldn’t look at it for a couple of...
Whilst removing my like-new-out-of-the-box 301 from its plinth I have managed to slip with the screwdriver whilst undoing one of the brass nuts underneath. I have managed to knock a small chip of paint from (of course) the front. Did it this morning and have just managed to exhale.
Has anyone...
I have a small system upstairs using a 303. I use a small passive rca input selector and a simple passive volume control which I think is very good vfm. I have kept connecting cables as short as possible. Sounds good to me...
If only all vinyl was up to this quality. I have lots of records and there are some that I avoid because they are tiring to listen to. This record was a pleasure from the sleeve to the sheen to the sound, if only they were all like this.
I just picked up a mint classical record from my local secondhand shop. It is Decca SXL 2006 and I am amazed at how good vinyl can sound. I know the SXL series are well known but the quality of the recording and pressing are at the top and I have listened through a whole side without a pop...
Have you seen this one?
https://www.ebay.co.uk/itm/266339597688?mkcid=1&mkrid=710-53481-19255-0&siteid=0&campid=5338728743&customid=&toolid=10001&mkevt=1
Fair price for these I believe? Would like to try a pair but too many speakers here at the moment:
https://www.ebay.co.uk/itm/204637747933?mkcid=1&mkrid=710-53481-19255-0&siteid=0&campid=5338728743&customid=&toolid=10001&mkevt=1
I have a 3012 arm and managed to lose the dashpot rubber ‘mushroom’ when cleaning and replacing coupling. I will replace this and then get to the business of trying to sort out the arm lowering action. There is a thread on another forum about this and I bought the following on their...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.