Richard Lines
pfm Member
Good Afternoon All,
Well the NCC300 boards arrived back from Graham at lunchtime so I've re-installed them.
Powered up via the Variac this time and was, essentially, seeing the same result so bailed out at 10V offset showing.
I had raised the issue of connecting the two 0V points on the CAP6/ MiniCap6's but hadn't realised it wasn't an option, they need to be connected together.
Both offsets less than 10mV -
I'll drag it in to the Hi-Fi Room later and get it tested using the Exactbox and test speaker before connecting it to the Sara9's.
Regards
Richard
Well the NCC300 boards arrived back from Graham at lunchtime so I've re-installed them.
Powered up via the Variac this time and was, essentially, seeing the same result so bailed out at 10V offset showing.
I had raised the issue of connecting the two 0V points on the CAP6/ MiniCap6's but hadn't realised it wasn't an option, they need to be connected together.
Both offsets less than 10mV -
I'll drag it in to the Hi-Fi Room later and get it tested using the Exactbox and test speaker before connecting it to the Sara9's.
Regards
Richard
Last edited: