DIY Voyager mono block build

[337alant]

So after a couple of years constant use my Voyagers are still singing beautifully
As an update I no longer have an input cap as I have a 10uf film cap on my pre amp and no longer have bye pass cap on the feed back cap. Today I checked the DC offset at 35-40mv and found both caps still in spec and no ESR
20171215_160113 by Alan Towell, on Flickr
20171215_160500 by Alan Towell, on Flickr

Alan

 

[bugbear]

How are the NCC200's physically fixed into the case/heatsink? If it's a screw/bolt through the lower arm of the 'U' shaped heat spreader it would be really difficult to access. If it's a bolt from the outside into threaded holes in the spreader it would mar the look of that lovely heatsink.

So I'm clearly missing something.

BugBear

 

[337alant]

It depends on the case you choose ?
The C shaped channel has threaded holes on the bottom flange so you can bolt them into a base plate from the under side of the case.
On the modushop disapante cases I use I have to drill and Tap the C channel on the side so it lines up with the bottom of the fins of the heat sinks with a pair of allen bolts so its hardly visible really

Alan